Slot Car Body 1/32 Scale - 2019 Indy Car (Road and Oval) - New Custom 3D Printed

Description

Plastic 1/32 scale SRX 2019 Indy Car Body.  3D
printed from PLA plastic.
The body Fits Scalextric Start F1 racing car C4114 and C4113 chassis  (Orange or Black F1 Cars).  You will need to trim radiator intake down .2 inches on the chassis, line up the chassis and install screws.
Body is made of PLA plastic and can be painted with acrylic, enamel, and plastic automotive paints.  For best result, spray with Rust-Oleum primer - 2 in 1 filler & sandable and then s
and with 400 or smooth grit paper.
Design
Wheel Base - 3.85 inches
Body Width - 2.5 inches
Total Length - 6.25 inches
Part included:
1 Body
1 Road Rear Wing
1 Road Front Wing
1 Oval Rear Wind
1 Oval Front Wing
4 wheel spacers  (.1 in)
Reminder:  Scalextric Start F1 Racing Car NOT INCLUDED.
32 Scale Indy Slot Car Assembly Tips
Remove body from Scalextric Start F1 car
Save 4 Screws
Remove rear Wing from chassis
Trim radiator intake on chassis by .25 inches located in front of middle mounting posts
Remove wheel from chassis and install spacer at each wheel
Install body on chassis using the 4 screws and verify fit
Finishing model tips
Use Super glue for wings and driver helmet
Use X-Acto knife to remove any flashing and printer supports
Use multiple coats of Rust-oleum Filler-Primer and sand lightly with 600 grit paper 90 degrees from the layer lines.
(fills the gaps between layer lines)
Reinstall finished body on chassis using 4 screws